Ningbo Anson Hi Series Error Ei084: Non-finished self-searching notch position

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEi084

Non-finished notch position self-searching because the previous search hasn't completed. The manual's first action is: “Clean the error, do notch position searching once again”

Model
Ningbo Anson Hi Series
Display shows
Non-finished self-searching notch position (Ei084)
Type
Error code
Source
Manual p. 87

What Ei084 means

Non-finished self-searching notch position p. 87

Common causes

  • Former self-searching notch position hasn't finished. p. 87

What to do

  1. Clean the error, do notch position searching once again p. 87

If Ei084 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 87 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Ei084; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.