Error codeEi07
Emulation encoder error occurs if FPAs is damaged or stimulated signal doesn't match the source angle variation. The manual's first action is: “1. Check whether the stimulated card has been refreshed. 2. Check whether the setting of the EU0D and EU02 are correct. 3. Seek for technical support”
- Model
- Ningbo Anson Hi Series
- Display shows
- Emulation encoder error (Ei07)
- Type
- Error code
- Source
- Manual p. 88
What Ei07 means
Emulation encoder error p. 88
Common causes
- 1. FPAs is damaged. 2. Stimulated signal can't match the variation of the stimulated source angle. p. 88
What to do
- 1. Check whether the stimulated card has been refreshed. 2. Check whether the setting of the EU0D and EU02 are correct. 3. Seek for technical support p. 88
If Ei07 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.
This page summarises what the manufacturer’s manual says about Ei07; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.