Ningbo Anson Hi Series Error Ei083: Encoder error

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEi083

Encoder error from loosened or disconnected wiring or internal wiring fault. The manual's first action is: “1.Check the encoder wiring connection 2.Seek for technical support”

Model
Ningbo Anson Hi Series
Display shows
Encoder error (Ei083)
Type
Error code
Source
Manual p. 87

What Ei083 means

Encoder error p. 87

Common causes

  • 1.Encoder loosens connection or disconnect. 2.Internal wiring fault p. 87

What to do

  1. 1.Check the encoder wiring connection 2.Seek for technical support p. 87

If Ei083 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 87 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Ei083; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.