Error codeEi08
Encoder 2 error happens when mechanical angle exceeds reference angle in encoder 2. The manual's first action is: “1. Checking the wiring 2. Exclude the interference”
- Model
- Ningbo Anson Hi Series
- Display shows
- Encoder 2 error (Ei08)
- Type
- Error code
- Source
- Manual p. 88
What Ei08 means
Encoder 2 error p. 88
Common causes
- Mechanical angle exceeds the reference angle in the encoder 2. p. 88
What to do
- 1. Checking the wiring 2. Exclude the interference p. 88
If Ei08 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.
This page summarises what the manufacturer’s manual says about Ei08; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.