Error codeEi068
Initial angle searching fails from incorrect encoder settings or wrong motor wiring sequence. The manual's first action is: “1.Modify the setting of the encoder mode (EC.01 or EC.02 or DR.06) 2.Adjust the motor wirings 3.Check whether the motor is stuck”
- Model
- Ningbo Anson Hi Series
- Display shows
- Searching initial angle fails (Ei068)
- Type
- Error code
- Source
- Manual p. 87
What Ei068 means
Searching initial angle fails p. 87
Common causes
- 1.Incorrect encoder setting (EC.01 or EC.02 or DR.06) 2.The motor wiring sequence hasn't followed by the connection sequence of red wire, blue wire and yellow wire. p. 87
What to do
- 1.Modify the setting of the encoder mode (EC.01 or EC.02 or DR.06) 2.Adjust the motor wirings 3.Check whether the motor is stuck p. 87
If Ei068 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.
This page summarises what the manufacturer’s manual says about Ei068; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.