Ningbo Anson Hi Series Error Ei060: The setting of PU.02 is wrong.

Servo drive · taken from the manufacturer’s manual, pages cited

Error codeEi060

PU.02 setting is incorrect when DR.00=0 or exceeds limit value when DR.00=3. The manual's first action is: “When DR.00=0, Reset PU.02 0-PU.02Smin(PU.12,DR.19) When DR.00=3, Adjust PU.02 or PU.03.”

Model
Ningbo Anson Hi Series
Display shows
The setting of PU.02 is wrong. (Ei060)
Type
Error code
Source
Manual p. 87

What Ei060 means

The setting of PU.02 is wrong. p. 87

Common causes

  • When DR.00=0, PU.02 (PU per unit current setting) is wrong. When DR.00=3 to PU.02 or PU.03 exceeds the limit value. p. 87

What to do

  1. When DR.00=0, Reset PU.02 0-PU.02Smin(PU.12,DR.19) When DR.00=3, Adjust PU.02 or PU.03. p. 87

If Ei060 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Ningbo Anson service.

Open the manual at page 87 All Hi Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about Ei060; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Ningbo Anson. Found a mistake? Report an error.