Mitsubishi Electric MDS-C1 Series Error ALM32: Overcurrent alarm occurs

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Alarm codeALM32

Overcurrent alarm occurs because the motor cannot follow due to insufficient tap time constant or excessive loop gains during synchronous tap control. The manual's first action is: “Readjust the tap time constant. Set a value double the value for the S command.”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Overcurrent alarm occurs (ALM32)
Type
Alarm code
Source
Manual p. 296

What ALM32 means

Overcurrent alarm occurs p. 296

Common causes

  • The motor cannot follow because the tap time constant is too short. p. 296
  • The speed loop gain is too high for synchronous tap control (Is there vibration when changing to synchronous control?) p. 296
  • The current loop gain is too high during synchronous tap control. p. 296
  • The closed loop and semi-closed loop settings for spindle control are incorrect. p. 296
  • The gear ratio setting is incorrect. p. 296

What to do

  1. Readjust the tap time constant. Set a value double the value for the S command. p. 296
  2. Set 100% as the standard. p. 296
  3. Set SP219, SP220 setting value to too large. Set 100% as the standard. p. 296
  4. Check which detector's FB is being used. Spindle ENC = full closed loop: SP193/bit0=0 Motor PLG = semi-closed loop: SP193/bit0=1 p. 296
  5. Check the machine gear ratio. Number of gear teeth on spindle side : SP025 to SP028 Number of gear teeth on motor side : SP029 to SP032 p. 296

Before you service the product, read the safety instructions in the manual p. 4.

If ALM32 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about ALM32; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.