Mitsubishi Electric MDS-C1 Series Error 19: Synchronous control/detector communication error

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code19

Synchronous control/detector communication error due to unconfigured master axis detector, cut-off communication, or cable/connector issues. The manual's first action is: “PR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Synchronous control/detector communication error (19)
Type
Error code
Source
Manual p. 309

What 19 means

Synchronous control/detector communication error p. 309

Common causes

  • Initial communication with the master axis motor end detector was not set. Or, when the closed current command synchronous control was set. Or the communication was cut off. p. 309
  • The connector is disconnected. p. 309
  • The cable is disconnected or incorrectly connected. p. 309
  • There is no abnormality in particular. p. 309

What to do

  1. PR p. 309
  2. Correctly connect. p. 309
  3. Replace the cable. p. 309
  4. Try replacing the drive unit or MDS-B-SD unit. p. 309

Before you service the product, read the safety instructions in the manual p. 4.

If 19 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 19; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.