Mitsubishi Electric MDS-C1 Series Error 18: Motor side detector, initial communication error

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code18

Motor side detector initial communication error because communication failed, value not set correctly, or connector is disconnected/loose. The manual's first action is: “PR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Motor side detector, initial communication error (18)
Type
Error code
Source
Manual p. 309

What 18 means

Motor side detector, initial communication error p. 309

Common causes

  • Initial communication with the motor end detector was not possible. p. 309
  • The value is not set correctly. p. 309
  • The connector is disconnected (or loose). p. 309
  • There is a connection fault. p. 309
  • The alarm is on the drive unit side. p. 309
  • No abnormality was found in particular. p. 309

What to do

  1. PR p. 309
  2. Correctly set SV025. p. 309
  3. Correctly install. p. 309
  4. Replace the detector cable. p. 309
  5. Replace the drive unit. p. 309
  6. Replace the detector. p. 309

Before you service the product, read the safety instructions in the manual p. 4.

If 18 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 18; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.