Mitsubishi Electric MDS-C1 Series Error 74: Regenerative resistor overheating

AC Servo/Spindle · taken from the manufacturer’s manual, pages cited

Error code74

Regenerative resistor overheating occurs when the temperature protection function activates in the resistor. The manual's first action is: “PR”

Model
Mitsubishi Electric MDS-C1 Series
Display shows
Regenerative resistor overheating (74)
Type
Error code
Source
Manual p. 312

What 74 means

Regenerative resistor overheating p. 312

Common causes

  • The temperature protection function in the regenerative resistor activated. p. 312
  • The resistor is overheated. p. 312
  • The resistor is not overheated. p. 312
  • Over-regeneration has not occurred before. p. 312
  • The wire is about to break. p. 312
  • There is no continuity at the resistor's thermal terminal. p. 312
  • There is no problem. p. 312

What to do

  1. PR p. 312
  2. Investigate item 2. p. 312
  3. Investigate item 3. p. 312
  4. Take measures to dissipate the regenerative resistor's heat. • Improve the ventilation. • Install a fan. p. 312
  5. Replace the wire. p. 312
  6. Replace the resistor unit. p. 312
  7. Replace the power supply unit. p. 312

Before you service the product, read the safety instructions in the manual p. 4.

If 74 is still not resolved

  • contact service / dealer p. 5
    “Wiring, maintenance and inspection work must be done by a qualified technician.”

This page summarises what the manufacturer’s manual says about 74; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.