Danfoss 100 FLOW Error ID 372: Device Added (Same Type)

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault codeID 372

An option board was installed into slot B that has been used before; drive uses existing parameter settings. The manual's first action is: “The device is ready for use. The drive starts to use the old parameter settings.”

Model
Danfoss 100 FLOW
Display shows
Device Added (Same Type) (ID 372)
Type
Fault code
Source
Manual p. 306

What ID 372 means

Device Added (Same Type) p. 306

Common causes

  • An option board was put into slot B. You have used the option board before in the same slot. p. 306

What to do

  1. The device is ready for use. The drive starts to use the old parameter settings. p. 306

If ID 372 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 306 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about ID 372; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.