Danfoss 100 FLOW Error ID 320: Fire Mode Enabled

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault codeID 320

Fire mode is enabled and protections are disabled or autoreset. The manual's first action is: “Check the parameter settings and the signals.”

Model
Danfoss 100 FLOW
Display shows
Fire Mode Enabled (ID 320)
Type
Fault code
Source
Manual p. 305

What ID 320 means

Fire Mode Enabled p. 305

Common causes

  • The fire mode of the drive is enabled. The protections of the drive are disabled or autoreset. p. 305

What to do

  1. Check the parameter settings and the signals. p. 305
  2. This alarm is reset automatically when fire mode is disabled. p. 305

If ID 320 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 305 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about ID 320; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.