Danfoss 100 FLOW Error ID 364: Device Changed (Same Type)

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault codeID 364

An option board in slot D was replaced with a previously used one; parameters will be restored from old settings. The manual's first action is: “Reset the fault. The drive starts to use the old parameter settings.”

Model
Danfoss 100 FLOW
Display shows
Device Changed (Same Type) (ID 364)
Type
Fault code
Source
Manual p. 306

What ID 364 means

Device Changed (Same Type) p. 306

Common causes

  • The option board in slot D was replaced by a new one that you have used before in the same slot. The device is ready to be used. p. 306

What to do

  1. Reset the fault. The drive starts to use the old parameter settings. p. 306

If ID 364 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 306 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about ID 364; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.