Danfoss 100 FLOW Error ID 361: Device Changed (Same Type)

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault codeID 361

A new power unit of the same size was installed; parameters are available in the drive. The manual's first action is: “Reset the fault. The drive reboots after you reset the fault.”

Model
Danfoss 100 FLOW
Display shows
Device Changed (Same Type) (ID 361)
Type
Fault code
Source
Manual p. 306

What ID 361 means

Device Changed (Same Type) p. 306

Common causes

  • The power unit was replaced by a new one that has the same size. The device is ready to be used. The parameters are available in the drive. p. 306

What to do

  1. Reset the fault. The drive reboots after you reset the fault. p. 306

If ID 361 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 306 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about ID 361; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.