The sample height exceeds the container's internal height, causing a fit error. The manual's first action is: “Change the sample height or/and the inside container height, then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- #601
- Type
- Error code
- Source
- Manual p. 424
What #601 means
SAMPLE IS OUT OF THE COMPLEX BOX CONTAINER. SEE THE SOURCE TABLE. p. 424
Common causes
- The sum of the height of the source layers is greater than the container inside height. p. 424
What to do
- Change the sample height or/and the inside container height, then try again. p. 424
Before you service the product, read the safety instructions in the manual p. 526.
If #601 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #601; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.