Some dimensions in the pipe template are negative, violating physical constraints. The manual's first action is: “Make sure that all dimensions of the sample are positive, then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- #951
- Type
- Error code
- Source
- Manual p. 426
What #951 means
A NEGATIVE DIMENSION VALUE IS INDICATED IN THE PIPE TEMPLATE. CHECK TABLE OF SAMPLE PARAMETERS. p. 426
Common causes
- Some of dimensions in the ‘pipe’ template were found to be negative. p. 426
What to do
- Make sure that all dimensions of the sample are positive, then try again. p. 426
Before you service the product, read the safety instructions in the manual p. 526.
If #951 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #951; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.