An invalid density unit was specified, such as not using G/CU.C, KG/CU.M, or LB/CU.FT. The manual's first action is: “The above error means that an invalid syntax was detected for the density unit. Change the density unit definition, then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- INVALID DENSITY UNIT. (#374)
- Type
- Error code
- Source
- Manual p. 424
What #374 means
INVALID DENSITY UNIT. p. 424
Common causes
- The geometry template description may indicate the density in any of the following units: G/CU.C means the gram per cubic centimeter; KG/CU.M means the kilogram per cubic meter; LB/CU.FT means the pound per cubic foot; If the density unit is not indicated, the G/CU.C is used as default. p. 424
What to do
- The above error means that an invalid syntax was detected for the density unit. Change the density unit definition, then try again. p. 424
Before you service the product, read the safety instructions in the manual p. 526.
If #374 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #374; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.