The pipe diameter is too small to accommodate source No.2 within its structure. The manual's first action is: “Make sure that source No.2 can be located inside the pipe, then try again.”
- Model
- Canberra 9233653E V3.0
- Display shows
- PIPE DIAMETER IS TOO SMALL. NOT ENOUGH ROOM FOR SOURCE No.2. (#952)
- Type
- Error code
- Source
- Manual p. 426
What #952 means
PIPE DIAMETER IS TOO SMALL. NOT ENOUGH ROOM FOR SOURCE No.2. p. 426
Common causes
- The pipe inside diameter is not enough to locate source No.2. p. 426
What to do
- Make sure that source No.2 can be located inside the pipe, then try again. p. 426
Before you service the product, read the safety instructions in the manual p. 526.
If #952 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Canberra service.
This page summarises what the manufacturer’s manual says about #952; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canberra. Found a mistake? Report an error.