Agilent E5061A/E5062A ENA Series Error Codes

52 codes from pages 326–334 of the manual

This is the list of error codes the Agilent manual gives for the E5061A/E5062A ENA Series ENA Series network analyzer. Find your code below and open it for what the manual says about its causes and what to do.

Error codes from p. 326

CodeWhat it meansPage
20 Additional standard needed p. 326
77 Additional test set calibration needed p. 326
-168 Block data not allowed p. 326
240 Calibration data lost p. 326
22 Calibration method not selected p. 326
-148 Character data not allowed p. 326
-100 Command error p. 327
-222 Data out of range p. 327
-104 Data type error p. 327
32 Ecal module not in appropriate RF path p. 327
-200 Execution error p. 327
-123 Exponent too large p. 327
-178 Expression data not allowed p. 327
-170 Expression error p. 327
31 Failed to configure ECal module p. 327
-131 Invalid suffix p. 330
53 Log sweep requires 2 octave minimum span p. 330
-109 Missing parameter p. 330
75 Multiport test set not enabled p. 330
56 Not enough points for connector model p. 330
52 No valid memory trace p. 330
-120 Numeric data error p. 330
-128 Numeric data not allowed p. 330
241 Power on test failed p. 332
61 Power unlevelled p. 332
120 Printer error p. 332
121 Print failed p. 332
-284 Program currently running p. 332
-112 Program mnemonic too long p. 332
-286 Program runtime error p. 332
-430 Query DEADLOCKED p. 332
-400 Query error p. 332
-410 Query INTERRUPTED p. 332
-420 Query UNTERMINATED p. 333
-440 Query UNTERMINATED after indefinite response p. 333
105 Recall failed p. 333
106 Save failed p. 333
50 Specified channel hidden p. 333
23 Specified error term dose not exist p. 333
21 Specified ports overlapped p. 333
51 Specified trace dose not exist p. 333
-150 String data error p. 333
-158 String data not allowed p. 333
-138 Suffix not allowed p. 333
-134 Suffix too long p. 333
-102 Syntax error p. 334
-310 System error p. 334
40 Target value not found p. 334
-124 Too many digits p. 334
-223 Too much data p. 334
-211 Trigger ignored p. 334
-113 Undefined header p. 334

Codes and descriptions are taken from the manufacturer’s manual; page numbers link to the PDF. ManualLib is not affiliated with Agilent. Found a mistake? Report an error.