Agilent E5061A/E5062A ENA Series Error 75: Multiport test set not enabled

ENA Series network analyzer · taken from the manufacturer’s manual, pages cited

Error code75

The multiport test set calibration is being performed while test set control is not enabled. The manual lists no action for this code.

Model
Agilent E5061A/E5062A ENA Series
Display shows
Multiport test set not enabled (75)
Type
Error code
Source
Manual p. 330

What 75 means

Multiport test set not enabled p. 330

Common causes

  • This error occurs when multiport test set calibration is performed while test set control is not enabled. p. 330

If 75 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Agilent service.

Open the manual at page 330 All E5061A/E5062A ENA Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about 75; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Agilent. Found a mistake? Report an error.