Agilent E5061A/E5062A ENA Series Error 40: Target value not found

ENA Series network analyzer · taken from the manufacturer’s manual, pages cited

Error code40

The target value was not found during marker search analysis or bandwidth search. The manual lists no action for this code.

Model
Agilent E5061A/E5062A ENA Series
Display shows
Target value not found (40)
Type
Error code
Source
Manual p. 334

What 40 means

Target value not found p. 334

Common causes

  • This error occurs when the target is not found during the marker search analysis after specifying the target and executing the CALC:MARK:FUNC:EXEC and CALC:FUNC:EXEC commands. This error occurs also when the bandwidth is not found after executing the bandwidth marker command, CALC:MARK:BWDATA? p. 334

If 40 is still not resolved

  • Contact your Agilent Technologies Sales and Service Office for service and repair to ensure that safety features are maintained in operational condition. p. 9
    “Agilent Technologies Sales and Service Office for service and repair to ensure that safety features are maintain ed in operational condition.”
Open the manual at page 334 All E5061A/E5062A ENA Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about 40; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Agilent. Found a mistake? Report an error.