Agilent E5061A/E5062A ENA Series Error 56: Not enough points for connector model

ENA Series network analyzer · taken from the manufacturer’s manual, pages cited

Error code56

The connector measurement function of the SRL measurement is performed with fewer than 101 points. The manual's first action is: “Use at least 101 points.”

Model
Agilent E5061A/E5062A ENA Series
Display shows
Not enough points for connector model (56)
Type
Error code
Source
Manual p. 330

What 56 means

Not enough points for connector model p. 330

Common causes

  • This error occurs when the connector measurement function of the SRL measurement is performed with the number of measurement points less than 101. p. 330

What to do

  1. Use at least 101 points. p. 330

If 56 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Agilent service.

Open the manual at page 330 All E5061A/E5062A ENA Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about 56; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Agilent. Found a mistake? Report an error.