Industrial

JO53 is a crystal oscillator produced by Jauch Quartz. It has a working frequency range of 0.5MHz to 80MHz, a working voltage of 2.5V, a temperature range of -10℃ to +70℃, and a frequency stability of ±50ppm. The output load is 15pF and 30pF.

This document introduces the features and characteristics of the M393B2G70AH0 and M393B2G73AH0 products, including the product's package type, memory capacity, operating voltage, operating frequency, and interface type.

This document describes the features and characteristics of the DDR3 memory modules, models M393B2G70AH0 and M393B4G70AM0, produced by Samsung Electronics.

NUP4103FC is an integrated transient voltage suppressor device (TVS) designed for applications requiring transient overvoltage protection. It is intended for use in sensitive portable equipment and other applications. Its integrated design provides very effective and reliable protection for four separate lines using only one package. These devices are ideal for situations where board space is a premium.

This document provides specifications and characteristics of American Accurate Components, Inc. NTC CHIP THERMISTOR, including dimensions, electrical characteristics, zero power resistance, and B value.

The NM27P040 is a 4096K Processor Oriented EPROM (POPTM) configured as 512K x 8. It is designed to simplify microprocessor interfacing while remaining compatible with standard EPROMs. It can reduce both wait states and glue logic when the specification improvements are taken advantage of in the system design. The NM27P040 is implemented in National’s advanced CMOS EPROM process to provide a reliable solution and access times as fast as 120 ns. The interface improvements address two areas to eliminate the need for additional devices to adapt the EPROM to the microprocessor and to eliminate wait states at the termination of the access cycle. Even with these improvements, the NM27P040 remains compatible with industry standard JEDEC pinout EPROMs. The time from CE or OE being negated until the outputs are guaranteed to be in the high impedance state has been reduced to eliminate the need for wait states at the termination of the memory cycle and the data-out hold time has been extended to eliminate the need to provide data hold time for the microprocessor by delaying control signals or latching and holding the data in external latches.

This is a MEMO to introduce the product information of NJW1102A.

This manual introduces the related information of NJU6322 series products, including product overview, pin definition, electrical characteristics, package form, application circuits and attention points.

NJM2374A is a PWM type DC/DC converter IC with a wide range of power supply voltage, wide operating frequency range, built-in power transistor and overcurrent detection circuit.

NJG1553BF is a GaAs MMIC MIXER IC from NJG, with built-in local amplifier for 1.9GHz PCS applications. This mixer features high conversion gain, low noise figure and low distortion.

NE527 is a product manual from Philips Semiconductors. It is a high-precision analog voltage comparator with 15ns propagation delay, complementary output gates, TTL or ECL compatible outputs, wide common-mode and differential voltage range, and 5000 typical gain.

TLG358T is a low-voltage, low-current dual operational amplifier with a voltage gain of 200, an input offset voltage of 100uV, an input bias current of 10uA, a bandwidth of 1MHz, and an output current of 25mA.