Industrial

This is the datasheet of STP12PF06 P-CHANNEL 60V - 0.18 Ω - 12A TO-220/TO-220FP STripFET™ II POWER MOSFET

STP11NM80, STB11NM80, STF11NM80 and STW11NM80 are N-Channel 800V, 0.35 Ohm, 11A TO-220/FP/D2PAK/TO-247 MDmesh™ Power MOSFETs with outstanding low on-resistance, impressively high dv/dt and excellent avalanche characteristics. This product is very suitable for single switch applications, especially for Flyback and Forward converter topologies.

This document is the specification of the STP9NM60N series products, which describes the features and characteristics of the products in detail, including pin definition, package type, electrical parameters, absolute maximum ratings, thermal data, avalanche characteristics and so on.

an1501 is an application note that introduces how microcontroller can be used in electronic ballast, and provides a brief introduction of the basic working principle of microcontroller and the advantages and disadvantages of implementing microcontroller in electronic ballast.

This application note describes a low cost power board design for the ST92141 motor control MCU without using IPMs.

This Application Note describes how to emulate this feature with a ST72F264 device and the restrictions this emulation implies.

This application note describes how to develop a USB Mass Storage application using an ST7265x microcontroller. The proposed solution includes a generic USB Mass Storage Layer (MSL) compliant with the USB Mass Storage Class that can be used for all types of storage media (FLASH memory cards, hard disk drive, etc.) and a dedicated Media Access Layer (MAL) add-in for each type of storage media. The MSL and the MAL modules are available to ST customers on request. Contact your ST sales office to obtain the ST7265 Mass Storage software. The MSL and the MAL must be considered as function libraries and therefore cannot be modified by the user. The software interfaces of these function libraries provide the user with the required flexibility for designing his application: – type and number of media, – insertion/withdrawal management, – protection management, – user interface. Note that the MAL requires the use of certain fixed MCU pins to interface with the various mediums. As a result, a specific application hardware configuration is required when using the MAL.

Describes how to use ST7 microcontroller's 8-bit SPI to emulate a 16-bit SPI slave

How to reduce 3rd harmonics with ST6200C motor control software

This AN1449 application note describes the software of a low-cost phase-angle motor control drive system based on an OTP version of the ST6200C microcontroller and a BTB16-600CW snubberless triac.

This document provides instructions for using Himax brushless motors, including the use of brushless sensorless speed controls, the proper way to connect the motor and ESC, the importance of cooling, and the prohibition of disassembling the motor.

This application note describes several low-cost power supply circuits for home appliance applications. These circuits can be built with simple components and are very cost-effective.

This application note provides guidelines on resolving several common application problems that have been reported by ST Application Engineers.

This document describes the features of PI6C39911, including all output pairs skew, output operation frequency, input operation frequency, user-selectable output functions, input-to-output delay, output duty cycle, input tolerance, LVTTL output driving 50-Ohm terminated lines, single 3.3V supply, low operating current, 32-pin PLCC package, jitter, etc.