Industrial

This application note presents the design of a clock system using the ST6-REALIZER. The clock system provides the following features: current time counting, alarm triggering at a defined time, current time setup, and alarm time setup. The application note presents a simple clock design with an alarm feature using the ST6-REALIZER.

This application note describes how to create a coded lock system using the ST6-REALIZER development tool. The system uses the ST62 MCU's embedded EEPROM to store the secret code and only allows the door to be unlocked when the same access code is entered.

AN839 application note introduces a technique for decoding multiple keys using only one I/O port pin. The technique is based on connecting the keys by a resistive voltage divider to the ADC input.

This application note describes the use of ST6-Realizer toolbox to develop MCU application.

This is an application note about designing a battery charger using ST6-REALIZER ®.

This note provides a technique for minimising the current consumption when using a crystal oscillator at 32 kHz with ST62 microcontroller.

This application note describes how to optimize the accuracy of the ST62 family micro-controllers' internal A/D converter. It includes instructions on how to filter analog input noise, how to put the MCU in wait state to minimize power supply noise, and how to make several successive A/D conversions and take an average of the results.

This document describes how to prevent EEPROM data corruption in ST6 devices, including software and hardware solutions

This document provides guidance on how to choose a resonator or quartz crystal in order to achieve reliable oscillation with the ST62 Microcontroller. The document first provides the major resonator parameters useful for a design. It then proposes measurement methods to ensure a safe oscillation.

This application note describes low-cost reset circuits for ST6 microcontrollers, including external reset circuitry and internal low voltage detector (LVD) reset circuitry, providing power-up and power-down monitoring, and delay power-on reset.

This application note describes how to drive a Liquid Crystal Display (LCD) with a standard ST62 microcontroller (MCU)

This note provides information on the steps required in order to perform in-circuit programming of ST62Exxx EPROM or OTP devices for both on-chip EPROM and EEPROM.

This document is the operating manual of Common Sense RC ACDC-6 6S Balancing Charger

This application note describes how to generate a digital signal locked in phase and frequency (PLL) with a calibrated delay starting from an active edge on the Auto-reload timer input pin.

This note presents how to use the Auto-reload timer (ARTimer) of the ST62 to measure durations or frequencies of an input signal.