Industrial

HCF4541B is a monolithic integrated circuit produced by Honeywell Corporation. It is mainly used as a timer and uses metal oxide semiconductor technology. It has two packaging forms: DIP and SOP. The device consists of a 16-stage binary counter, an oscillator controlled by two external resistors and a capacitor, an output control logic and an automatic power-on reset circuit. The counter can change at the positive edge clock transition and can be cleared by the MASTER RESET input. The output of this timer is the Q or Q output from the 8th, 13th, or 16th counter stage. The choice of the stage depends on the time.

HCF4030B is a monolithic integrated circuit fabricated in Metal Oxide Semiconductor technology available in DIP and SOP packages. It consists of four indipendent exclusive-OR gates integrated on a single monolithic silicon chip. Each exclusive-OR gate consists of four n-channel and four p-channel enhancement-type transistors. All inputs and outputs are protected against electrostatic effects.

The HCF4014B is a monolithic integrated circuit fabricated in Metal Oxide Semiconductor technology. It is an 8-stage parallel or serial input/serial output register with master-slave flip-flops and output buffering. It operates at medium speed and is fully static. The device meets all requirements of JEDEC JESD13B standard.

The M22100 is a 4x4 crosspoint switch with built-in control latches and large analog signal capability. It can transmit signals up to 10 MHz and has matched switch characteristics, high linearity, and standard COS/MOS noise immunity.

M74HCU04 is a high speed CMOS Hex Invertor (Single State) fabricated with silicon gate C2MOS technology. As internal circuit is composed of a single stage inverter, it can be used in crystal oscillator. All inputs are equipped with protection circuits against static discharge and transient excess voltage.

M74HCT74 is a CMOS DUAL D TYPE FLIP FLOP WITH CLEAR, which has the characteristics of high speed, low power consumption, and compatibility with TTL. It is suitable for direct interface with HSC2MOS systems, TTL and NMOS components.

M74HCT7007 is a CMOS HEX BUFFER with high speed, low power consumption and TTL-compatible output characteristics.

This document describes the features of the 74HCT540 model, including high-speed transmission, low power dissipation, and compatibility with TTL outputs.

M74HCT374 is a high speed CMOS OCTAL D-TYPE FLIP FLOP WITH 3-STATE OUTPUTS NON INVERTING fabricated with silicon gate C2MOS technology.

The M74HCT373 is a high-speed CMOS octal latch with 3-state outputs. It is fabricated with sub-micron silicon gate C2MOS technology and features high speed, low power dissipation, and compatibility with TTL outputs.

M74HCT367 is a high-performance CMOS hex buffer with 3-state outputs. This device consists of six buffers, four buffers are controlled by an enable input (G1) and the other two buffers are controlled by the other enable input (G2); the outputs of each buffer group are enabled when G1 and/or G2 inputs are held low, and when held high, these outputs are disabled in a high-impedance state. All inputs are equipped with protection circuits against static discharge and transient excess voltage.

M74HCT32 is a high-speed CMOS QUAD 2-INPUT OR GATE with features of high speed, low power dissipation, compatibility with TTL outputs, etc.

This datasheet provides detailed information on M74HCT273 and its pin diagram, function block diagram, truth table, logic circuit diagram, etc.