Philips Manuals - Page 109

Philips manuals, page 109

• PHILIPS 74HC123 74HCT123 DATA SHEET

  The 74HC123; 74HCT123 high-speed Si-gate CMOS devices are pin compatible with low power Schottky TTL (LSTTL). They are specified in compliance with JEDEC standard no. 7A. The 74HC123; 74HCT123 are dual retriggerable monostable multivibrators with output pulse width control by three methods: 1. The basic pulse time is programmed by selection of an external resistor (REXT) and capacitor (CEXT). 2. Once triggered, the basic output pulse width may be extended by retriggering the gated active LOW-going edge input (nA) or the active HIGH-going edge input (nB). By repeating this process, the output pulse period (nQ = HIGH, nQ = LOW) can be made as long as desired. Alternatively an output delay can be terminated at any time by a LOW-going edge on input nRD, which also inhibits the triggering. 3. An internal connection from nRD to the input gates makes it possible to trigger the circuit by a HIGH-going signal at input nRD as shown in the function table. Schmitt-trigger action in the nA and nB inputs, makes the circuit highly tolerant to slower input rise and fall times. The 74HC123; 74HCT123 is identical to the 74HC423; 74HCT423 but can be triggered via the reset input.

• Philips TJA1040 High speed CAN transceiver datasheet

  TJA1040 is a high-speed CAN transceiver, fully compatible with the ISO 11898 standard. It features high-speed transmission, low-power standby mode, remote wake-up capability, low electromagnetic emission, and high common-mode range differential receiver. It supports 3.3V and 5V devices, and up to 110 nodes can be connected.

• philips SRU5110/86 User Manual

  SRU5110/86 EN is a universal remote control from Philips that can operate the most commonly used functions of almost any brand of TV.

• philips SRP4004/86 User Manual

  The Philips SRP4004 is a universal remote control that can operate up to 4 different devices. It features Philips' patented Simple Setup technology, making it easy to set up for TV, DVD players/recorders, VCRs, and common set-top boxes. The remote control has glow buttons that light up in the dark, enabling easy use even in dimly lit rooms.

• philips SJA1000 Stand-alone CAN controller DATA SHEET

  SJA1000 is a stand-alone CAN controller with multiple functional modules, including interface management logic, transmit buffer, receive buffer, acceptance filter, bit stream processor, bit timing logic, error management logic, etc.

• PHILIPS SC28C94 Quad universal asynchronous receiver/transmitter (QUART) handbook

  This document is a data sheet for the SC28C94 quad universal asynchronous receiver/transmitter (QUART) produced by Philips Semiconductors.

• PHILIPS P89LPC930/931 Manual

  The P89LPC930/931 are single-chip microcontrollers designed for applications demanding high-integration, low cost solutions over a wide range of performance requirements. The P89LPC930/931 is based on a high performance processor architecture that executes instructions in two to four clocks, six times the rate of standard 80C51 devices. Many system-level functions have been incorporated into the P89LPC930/931 in order to reduce component count, board space, and system cost.

• PHILIPS BTA204S series D E F BTA204M series D E F Three quadrant triacs guaranteed commutation Data Sheet

  This data sheet describes the product specifications of BTA204S and BTA204M series D, E and F three-quadrant triacs. These devices are suitable for use in active motor control circuits or with other highly inductive loads.

• PHILIPS P83C557E6/P80C557E6 Single-chip 8-bit microcontroller handbook

  The P83C557E6/P80C557E6 is a single-chip 8-bit microcontroller produced by Philips. It features an 80C51 central processing unit, 48K × 8 ROM, 1536 × 8 RAM, two standard 16-bit timer/counters, a 10-bit ADC, two 8-bit resolution, pulse width modulation outputs, five 8-bit I/O ports, an I2C-bus serial I/O port, full-duplex UART, on-chip watchdog timer, 15 interrupt sources, 2 priority levels, 4.5 to 5.5 V power supply range, 3.5 MHz to 16 MHz frequency range, PLL oscillator, 32 kHz reference and software-selectable system clock frequency, seconds timer, software enable/disable of ALE output pulse, electromagnetic compatibility improvements, wake-up from power-down by external or seconds interrupt

• PHILIPS BB149A handbook

  The BB149A is a planar technology variable capacitance diode from Philips, in a SOD323 very small plastic SMD package. It has very good linearity and excellent matching performance, and can be used for electronic tuning and VCO.

• PHILIPS BB170 handbook

  BB178 is a variable capacitance diode from Philips. It uses planar technology and is packaged in a SOD523 (SC-79) ultra small plastic package. The device has excellent linearity and matching performance and can be used in VHF television tuners and VCOs.

• PHILIPS BAT721 series handbook

  This datasheet introduces the features, applications and specifications of Philips Semiconductors BAT721 series Schottky diodes.

• PHILIPS BAS19/20/21 handbook

  BAS19;BAS20;BAS21 are general purpose diodes fabricated in planar technology, and encapsulated in a small SOT23 plastic SMD package. They have a switching speed of 50ns, a maximum continuous reverse voltage of 100V, a maximum repetitive peak reverse voltage of 120V and a maximum repetitive peak forward current of 625mA.

• PHILIPS BAS70 series; 1PS7xSB70 series handbook

  This document provides an overview, features, and applications of a series of general-purpose surface-mounted diodes.

• PHILIPS BC846W BC847W Manual

  BC846W and BC847W are NPN general purpose transistors with low current and low voltage characteristics. Suitable for general purpose switching and amplification applications.

Philips manuals by category