STMicroelectronics manuals, page 88
ST L6520 L6521 handbook
This document describes the highly integrated ballast controller L6520 and L6521, which features a half bridge circuit capable of driving both BJT and MOSFET transistors, a very accurate oscillator with precision in a wide operating temperature range, BJT's storage time compensation, preheated start and instant start, hard switching protection, overcurrent/voltage protection, choke saturation control, and end-of-life protection. It is suitable for electronic ballasts and integrated CFLs applications.
ST MCR100-3 MCR100-8 handbook
This document describes the features and characteristics of the MCR100-3 to MCR100-8 models, including peak forward and reverse blocking voltage, forward current, and peak forward surge current.
ST TL1431 handbook(1)
The TL1431 is a programmable shunt voltage reference with guaranteed temperature stability over the entire temperature range of operation. The output voltage may be set to any value between Vref (approximately 2.5V) and 36V with two external resistors. The TL1431 operates with a wide current range from 1 to 100mA with a typical dynamic impedance of 0.2Ω.
ST SMA6J handbook
SMA6J Transil™ Planar technology makes it compatible with high-end equipment like automotive, medical equipment or SMPS where low leakage current and high junction temperature are required to provide reliability and stability over time.
ST SMA540B handbook
This document is the datasheet of SMA540B, which introduces the features and characteristics of the product.
ST SMA428A handbook
This data sheet provides technical parameters of SMA428A high gain low noise amplifier. Its features include high gain ([email protected]), low noise ([email protected]), low current consumption (5.9mA), open collector output, typical supply voltage range of 2.4-3V, 35dB gain step mode and ultra miniature SOT323-6L package (lead free) with dimensions of 1.15mmx1.8mm and thickness of 0.8mm.
ST SMA427A handbook
This document introduces a 50Ω / 50Ω low noise amplifier model SMA427A. The amplifier features cascading capability, unconditional stability, a gain of 17 dB at 1.8 GHz, an IP3out of +7.4 dBm at 1.575 GHz, and a noise figure of 2.2 dB at 1.8 GHz.
ST ST7 KEYPAD DECODING TECHNIQUES Application Note
This application note presents an example of the use of the HALT mode. In this application, the MCU (here a ST72251) is waked up by an external interrupt caused by someone pressed a key on the 4x4 matrixed keypad.
ST HMC337 handbook
ST HMC336MS8G handbook
HMC336MS8G is a low cost, high performance GaAs MMIC SPDT switch from Hittite Corporation. It covers the frequency range of DC to 6.0GHz and offers high isolation and low insertion loss. The switch operates using a positive control voltage of 0/+5 Volts, and requires a fixed bias of +5V. This switch is suitable for usage in 50-Ohm or 75-Ohm systems.
ST HMC335G16 handbook
The HMC335G16 is a broadband 5-bit GaAs IC digital attenuator from Hittite Corporation. It covers DC to 3 GHz and has an insertion loss of less than 2.3 dB. The attenuation range is 1-31 dB.
ST HMC333 handbook
The HMC333 is a single balanced mixer IC with an integrated LO amplifier. This converter IC can operate as an upconverter or downconverter between 3.0 GHz and 3.8 GHz. With the integrated LO amplifier, the mixer requires an LO drive level of only 0 dBm, and requires only 7 mA from a single positive +3V rail. The mixer has 8.5 dB of conversion loss, an input P1dB of 0 dBm and an input third order intercept point of +10 dBm at 3.5 GHz.
ST HMC332 handbook
HMC332 is a single balanced mixer IC with an integrated LO amplifier produced by Hittite company. It can operate as an upconverter or downconverter between 2.0-2.8GHz. The mixer has 8dB of conversion loss, an input P1dB of 0dBm, and an input third order intercept point of +10dBm.
ST ST72C171 handbook
ST72C171 is an 8-bit MCU with features including 8K flash, ADC, WDG, SPI, SCI, and timers. It also has in-situ programming, low power oscillators, multifunctional IO ports, and software programmable gain amplifiers.
ST ST72141K handbook(3)
ST72141K 8-bit MCU with electric-motor control, ADC, 16-bit timers, SPI interface