TEXAS Manuals (Industrial)

The TPA2015D1 is a high efficiency Class-D audio power amplifier from TI with battery-tracking SpeakerGuard™ AGC technology and an integrated adaptive boost converter that enhances efficiency at low output power. It drives up to 2 W into an 8 Ω speaker (6% THD). With 85% typical efficiency, the TPA2015D1 helps extend battery life when playing audio.

File format: PDF Size:866 KB

SN54LS245, SN74LS245 are octal bus transceivers with 3-state outputs designed by Texas Instruments. These products are designed for asynchronous two-way communication between data buses. The control-function implementation minimizes external timing requirements. The devices allow data transmission from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE) input can disable the device so that the buses are effectively isolated.

File format: PDF Size:514 KB

This document introduces the features and characteristics of the Schmidt SCHS122I series, including range, switch voltage, noise immunity, etc.

File format: PDF Size:332 KB

The MPY634 is a wide bandwidth, high accuracy, four- quadrant analog multiplier manufactured by Texas Instruments. It has wide bandwidth, high accuracy, easy to use, low cost, etc. It can be used for a variety of precision analog signal processing, modulation and demodulation, voltage-controlled amplifiers, video signal processing, etc.

File format: PDF Size:428 KB

The BENCHMARQ bq2057 series advanced Lithium-Ion (Li-Ion) and Lithium-Polymer (Li-Pol) linear charge-management ICs are designed for cost-sensitive and compact portable electronics. They combine high-accuracy current and voltage regulation, battery conditioning, temperature monitoring, charge termination, charge-status indication, and AutoComp to improve performance, lower cost and enable smaller size.

File format: PDF Size:486 KB

The ADS1246, ADS1247, and ADS1248 are highly-integrated, precision, 24-bit analog-to-digital converters (ADCs). They feature an onboard, low-noise, programmable gain amplifier (PGA), a precision delta-sigma ADC with a single-cycle settling digital filter, and an internal oscillator. The ADS1247 and ADS1248 also provide a system monitor, programmable digital filter, and dual-channel current DACs.

File format: PDF Size:1290 KB

This datasheet provides SN54LVC541A and SN74LVC541A octal buffer/driver features, including pinout, package, input voltage, output voltage, operating voltage range, pull current, package etc.

File format: PDF Size:546 KB

The SN74LVC245A is an octal bus transceiver designed for 1.65-V to 3.6-V VCC operation. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE) input can be used to disable the device so the buses effectively are isolated.

File format: PDF Size:980 KB

This is the datasheet of TI's DAC7568, DAC8168, DAC8568, which are low-power, eight-channel, 12/14/16-bit digital-to-analog converters (DACs), with 2.5V, 2ppm/°C internal reference, programmable attenuation, digital gain and offset adjustment, programmable voltage and current sources.

File format: PDF Size:2157 KB

The SCP121B is a serial parallel expander that can be addressed through 3 hardware address pins for use with up to 8 devices. It features low standby current consumption, a 400 kHz Fast I2C bus, open-drain interrupt output, compatibility with most microcontrollers, and the ability to directly drive LEDs.

File format: PDF Size:721 KB

This document describes the features and characteristics of SN54ALS541, SN74ALS540, SN74ALS541 octal buffers and line drivers, including 3-state outputs, reduced dc loading, data flowthrough pinout, etc.

File format: PDF Size:513 KB

The document describes the features and characteristics of Harris Semiconductor SCHS136E, including buffered inputs and outputs, propagation delay, serial or parallel expansion, etc.

File format: PDF Size:354 KB

The PCA9536 is a remote 4-bit I2C and SMBus I/O expander with configuration registers from TI. It can be configured as inputs or outputs, has low standby current consumption, no glitch on power up, can directly drive LEDs, supports 5V tolerant I/O ports and has ESD protection.

File format: PDF Size:768 KB

The bq2002E/G is a low-cost CMOS battery charge controller providing reliable charge termination for both NiCd and NiMH battery applications.

File format: PDF Size:269 KB

The MSP430F42x0 is a family of ultralow-power microcontrollers from Texas Instruments. It consists of several devices with different sets of peripherals targeted for various applications. The architecture, combined with five low power modes, is optimized to achieve extended battery life in portable measurement and control applications.

File format: PDF Size:1273 KB

ADS807 is a high-precision, high dynamic range, 12-bit, 53MHz sampling analog-to-digital converter.

File format: PDF Size:321 KB

This document introduces the features and characteristics of TMS320VC33 series, including the processor model, floating point operation capability, instruction cycle, etc.

File format: PDF Size:833 KB

The TS5A3159A is a single-pole double-throw (SPDT) analog switch that is designed to operate from 1.65 V to 5.5 V. The device offers low on-state resistance and excellent on-state resistance matching with the break-before-make feature, to prevent signal distortion during the transferring of a signal from one channel to another. The device has an excellent total harmonic distortion (THD) performance and consumes very low current.

File format: PDF Size:521 KB

The ADS1259 is a high-linearity, low-drift, 24-bit, analog-to-digital converter (ADC) designed for the needs of industrial process control, precision instrumentation, and other exacting applications.

File format: PDF Size:735 KB

SCHS173C is a low-power latch produced by Harris Semiconductor. It has four operating modes, a typical propagation delay of 15ns, a working voltage range of 2V-6V, buffered inputs and outputs, and a wide operating temperature range of -55oC-125oC. It is compatible with LSTTL circuits.

File format: PDF Size:277 KB