MICROCHIP Manuals (Industrial)

MCP3302/04 13-bit A/D converters feature full differential inputs and low power consumption in a small package that is ideal for battery powered systems and remote data acquisition applications. The MCP3302 is programmable to provide two differential input pairs or four single ended inputs. The MCP3304 is programmable and provides four differential input pairs or eight single ended inputs. Incorporating a successive approximation architecture with on-board sample and hold circuitry, these 13-bit A/D converters are specified to have ±1 LSB Differential Nonlinearity (DNL); ±1 LSB Integral Nonlinearity (INL) for B-grade and ±2 LSB for C-grade devices. The industry-standard SPI™ serial interface enables 13-bit A/D converter capability at up to 100 ksps sampling rate.

File format: PDF Size:659 KB

24AA16 is a 1.8 volt 16K bit Electrically Erasable PROM from Microchip Technology Inc. The device is organized as eight blocks of 256 x 8-bit memory with a 2-wire serial interface. Low voltage design permits operation down to 1.8 volts with standby and active currents of only 3 µ A and 1 mA, respectively. The 24AA16 also has a page-write capability for up to 16 bytes of data. The 24AA16 is available in the standard 8-pin DIP and both 8-lead and 14-lead surface mount SOIC packages.

File format: PDF Size:74 KB

This document introduces the CMOS flash microcontroller PIC16F946 from Microchip, which adopts nanowatt technology and has 64 pins and an LCD driver. The document provides useful information about the performance and usage of the product.

File format: PDF Size:4916 KB

This manual describes the PIC16F87XA series devices, including device features, pin assignments, interfaces, registers, instruction descriptions, programming environment and application notes.

File format: PDF Size:4371 KB

This data sheet introduces the features of the PIC16C77 series microcontrollers

File format: PDF Size:1869 KB

This data sheet describes the features of the Microchip Technology Inc. DS30221A microcontroller.

File format: PDF Size:1322 KB

This document describes the features and characteristics of Microchip Technology Inc.'s 28C16A product, including fast read access time, low power dissipation, fast byte write time, long data retention, and high endurance.

File format: PDF Size:64 KB

This file introduces the features of TC650/TC651, including integrated temperature sensor and multi-speed fan control, built-in over temperature alert(TOVER), temperature proportional fan speed control, pulse width modulation output drive, solid-state temperature sensing, ±1°C(typical) accuracy etc.

File format: PDF Size:441 KB

TC4626/TC4627 are single CMOS high speed drivers with an on-board voltage boost circuit. These parts work with an input supply voltage from 4 to 6 volts. The internal voltage booster will produce a VBOOST potential up to 12 volts above VIN. This VBOOST is not regulated, so its voltage is dependent on the input VDD voltage and output drive loading requirements. An internal undervoltage lockout circuit keeps the output in a low state when VBOOST drops below 7.8 volts. Output is enabled when VBOOST is above 11.3 volts.

File format: PDF Size:463 KB

The TC1413/TC1413N are 3A CMOS buffer/drivers with a wide operating range of 4.5V to 16V and can withstand up to 5V of negative input. They also have a short delay time of 35nsec.

File format: PDF Size:438 KB

Introduction of PIC16F630/676 data sheet, including device characteristics, application examples, and user guides

File format: PDF Size:2652 KB

This document describes the programming specifications for PIC18F2XX0/2X21/2XX5/4XX0/4X21/4XX5 devices, including the hardware requirements, pin diagrams, and programming timing requirements.

File format: PDF Size:774 KB

File format: PDF Size:0 KB

This data sheet introduces the core features, peripheral features, pin diagram, etc. of the DS30275A microcontroller.

File format: PDF Size:2903 KB

This document introduces Microchip MCP1252/3 inductorless buck/boost DC/DC converters' features and characteristics.

File format: PDF Size:440 KB

TC500/A/510/514 is a precision analog signal processor from Microchip with up to 17-bit precision, 3-pin control interface, single supply operation, automatic input voltage polarity detection, low power consumption, wide voltage range, etc., suitable for precision analog signal processing, precision sensor interface, high-precision DC measurement and other applications.

File format: PDF Size:566 KB

24C01A/02A/04A is a 1K/2K/4K bit Electrically Erasable PROM produced by Microchip Technology Inc. The device is organized with a standard two wire serial interface and features low power CMOS technology, hardware write protection, and self-timed write cycle (including auto-erase). The device offers a single byte write cycle time of 1ms, data retention time of over 200 years, and is guaranteed for 1,000,000 erase/write cycles. 24C01A/02A/04A is available in 8-pin DIP/SOIC packages and extended temperature range devices.

File format: PDF Size:75 KB

This document includes the programming specifications for PIC12C67X and PIC12CE67X. These devices have the capability of serial programming, allowing programming while in the user's system. The document also provides information on hardware requirements and programming mode.

File format: PDF Size:90 KB

PIC12C508 and PIC12C509 are 8-bit microcontrollers packaged in 8-lead packages. They are based on the Enhanced PIC16C5X family.

File format: PDF Size:1605 KB

This document introduces the programming specifications for PIC12C67X and PIC12CE67X, including hardware requirements, programming mode, program mode entry, program memory programming, etc.

File format: PDF Size:90 KB