TEXAS Manuals (Industrial)

The SN74BCT2423A, SN74BCT2424A is a 16-bit latched multiplexer/demultiplexer bus transceiver with the following features: Multiplexed real-time and latched data, Byte control for byte-write applications, Useful in NuBus interface applications, Useful in Memory Interleave Applications, BiCMOS design substantially reduces standby current, Dependable Texas Instruments Quality and Reliability.

File format: PDF Size:204 KB

SN74ALVCH162244 is a 16-bit buffer/driver in the Texas Instruments Widebus family. It uses the Enhanced Performance Implanted CMOS (EPIC) submicron process, and the output ports have equivalent 26-ohm series resistors, so no external resistors are required.

File format: PDF Size:204 KB

SN54AHCT16541 and SN74AHCT16541 are 16-bit buffers/drivers with 3-state outputs. They are fabricated using the EPIC (Enhanced-Performance Implanted CMOS) process, and the inputs are TTL-voltage compatible. Distributed VCC and GND pins minimize high-speed switching noise, and the flow-through architecture optimizes PCB layout. The latch-up performance exceeds 250 mA per JESD 17. Package options include plastic shrink small-outline (DL), thin shrink small-outline (DGG), and thin very small-outline (DGV) packages, as well as a 380-mil fine-pitch ceramic flat (WD) package with 25-mil center-to-center spacings. The devices consist of two 8-bit sections with separate output-enable signals. The outputs of each section are active only when both output-enable inputs are low. If either output-enable input is high, the outputs of that section are in the high-impedance state. To ensure the high-impedance state during power up or power down, the output-enable signals should be tied to VCC through pullup resistors, with the minimum value determined by the current-sinking capability of the driver. The SN54AHCT16541 is characterized for operation over the full military temperature range of -55°C to 125°C, while the SN74AHCT16541 is characterized for operation from -40°C to 85°C.

File format: PDF Size:98 KB

SN54ABT853, SN74ABT853 are 8-bit to 9-bit parity bus transceivers with high reliability, low power consumption, ESD protection, and high-drive outputs.

File format: PDF Size:142 KB

SN65HVD50-SN65HVD55 SN65HVD56-SN65HVD59 are TI's RS-485 drivers and receivers with 1/8 unit load option supporting up to 256 nodes on the bus. This product has 15 kV HBM bus pin ESD protection, optional driver output transition time, low current standby mode (< 1 μA), glitch-free power-up and power-down bus I/Os, bus idle, open, and short circuit failsafe protection, meets or exceeds the requirements of ANSI TIA/EIA-485-A and RS-422 compatible standards.

File format: PDF Size:1548 KB

CD54HC157, CD54HCT157, CD54HC158, CD54HCT158 are quad 2-input multiplexers which select four bits of data from two sources under the control of a common Select input (S).

File format: PDF Size:35 KB

This datasheet introduces the DAC9881 device from TI. It is a 18-bit single-channel low-noise voltage-output digital-to-analog converter. The device features 18-bit monotonicity, excellent linearity, very low noise and fast settling time. The device's on-chip precision output amplifier allows rail-to-rail output swing to be achieved over the full supply range of 2.7V to 5.5V. The device supports a standard SPI serial interface capable of operating with input data clock frequencies up to 50MHz. The DAC9881 requires an external reference voltage to set the output range of the DAC channel. A programmable power-on reset circuit is also incorporated into the device to ensure that the DAC output powers up at zero-scale or midscale, and in the power-down mode the output can be turned off.

File format: PDF Size:1459 KB

TPS65820 is a single-cell lithium-ion battery and power management IC from ti, which has host interface, battery charger, integrated power supply and other functions.

File format: PDF Size:2374 KB

The TLV5604 is a quadruple 10-bit voltage output digital-to-analog converter (DAC).

File format: PDF Size:383 KB

MSP430x22x2, MSP430x22x4 Mixed Signal Microcontrollers are low-power, low-voltage microcontrollers with ultrafast wake-up time from standby mode and a 16-bit RISC architecture. The product supports various clock configurations and communication interfaces, and is equipped with a 10-bit A/D converter and configurable operational amplifiers. Additionally, it features security protection to prevent program reading.

File format: PDF Size:2103 KB

This document introduces the features and characteristics of the DIT4096 digital audio transmitter. The product complies with AES-3, IEC-60958 and EIAJ CP1201 interface standards, supports sampling rates up to 96kHz, supports mono mode operation, integrates differential line driver, has a flexible audio serial interface, supports I2S, left-aligned and right-aligned data formats, supports software mode and hardware mode, and supports CRC code generation.

File format: PDF Size:541 KB

The TLV5606 is a 10-bit voltage output digital-to-analog converter (DAC) with a flexible 4-wire serial interface. It can be used in a wide range of applications, including digital servo control loops, digital offset and gain adjustment, industrial process control, machine and motion control devices, and mass storage devices.

File format: PDF Size:435 KB

TLV5614 is a quadruple 12-bit voltage output digital-to-analog converter (DAC) with a flexible 4-wire serial interface.

File format: PDF Size:404 KB

12-Bit Voltage Output DAC, supports TMS320 and SPI serial port, working voltage range is 2.7V to 5.5V, ultra low power consumption.

File format: PDF Size:456 KB

THS4041/2 165MHz C-Stable High-Speed Amplifiers is a single/dual, high-speed voltage feedback amplifier capable of driving any capacitive load. This makes them ideal for a wide range of applications including driving video lines or buffering ADCs. The device features high 165-MHz bandwidth and 400-V/µsec slew rate. The THS4041/2 are stable at all gains for both inverting and noninverting configurations. For video applications, the THS4041/2 offer excellent video performance with 0.01% differen- tial gain error and 0.01° differential phase error. These amplifiers can drive up to 100 mA into a 20-Ω load and operate off power supplies ranging from ±5V to ±15V.

File format: PDF Size:453 KB

File format: PDF Size:0 KB

SN54BCT374, SN74BCT374 is an 8-bit D flip-flop produced by Texas Instruments. Its feature is that it has 3-state outputs, which can be used to drive high-capacitance or relatively low-impedance loads. It is suitable for implementing buffer registers, I/O ports, bidirectional bus drivers and working registers.

File format: PDF Size:502 KB

TPS777xx and TPS778xx are designed to have a fast transient response and be stable with a 10-µF low ESR capacitors. This combination provides high performance at a reasonable cost.

File format: PDF Size:311 KB

TPS73xx devices are members of a family of micropower low-dropout (LDO) voltage regulators

File format: PDF Size:639 KB

The TPS4005x is a family of high-voltage, wide input, synchronous, step-down converters suitable for automotive applications. It offers design flexibility with a variety of user programmable functions, including soft-start, UVLO, operating frequency, voltage feed-forward, high-side current limit, and loop compensation.

File format: PDF Size:341 KB