TEXAS Manuals (Industrial)

This data manual describes the features and usage of TMS320F2810, TMS320F2811, TMS320F2812 and TMS320C2810, TMS320C2811, TMS320C2812 Digital Signal Processors.

File format: PDF Size:2018 KB

TM2SN64EPH and TM4SN64EPH are two synchronous dynamic random access memory (SDRAM) modules that can be used in 66MHz 4-Clock systems. They use a single 3.3V power supply and support read latencies 2 and 3. Both modules support byte read/write capability and have a high performance range, high speed, low noise, low voltage TTL (LVTTL) interface, support burst interleave and burst interrupt operations, burst length programmable to 1, 2, 4 and 8, have two banks for on-chip interleaving (gapless access), an ambient temperature range of 0°C to 70°C, gold-plated contacts, a pipeline architecture and use EEPROM for serial presence detection (SPD).

File format: PDF Size:236 KB

The TLV245x is a family of rail-to-rail input/output operational amplifiers that sets a new performance point for supply current and ac performance. These devices consume a mere 23 µA/channel while offering 220 kHz of gain-bandwidth product, much higher than competitive devices with similar supply current levels. Along with increased ac performance, the amplifier provides high output drive capability, solving a major shortcoming of older micropower rail-to-rail input/output operational amplifiers. The TLV245x can swing to within 250 mV of each supply rail while driving a 2.5-mA load. Both the inputs and outputs swing rail-to-rail for increased dynamic range in low-voltage applications. This performance makes the TLV245x family ideal for portable medical equipment, patient monitoring systems, and data acquisition.

File format: PDF Size:1116 KB

The TLE207x series of JFET-input operational amplifiers more than double the bandwidth and triple the slew rate of the TL07x and TL08x families of BiFET operational amplifiers. Texas Instruments Excalibur process yields a typical noise floor of 11.6 nV/√Hz, 17-nV/√Hz ensured maximum, offering immediate improvement in noise-sensitive circuits designed using the TL07x. The TLE207x also has wider supply voltage rails, increasing the dynamic signal range for BiFET circuits to ±19 V. On-chip zener trimming of offset voltage yields precision grades for greater accuracy in dc-coupled applications. The TLE207x are pin-compatible with lower performance BiFET operational amplifiers for ease in improving performance in existing designs. BiFET operational amplifiers offer the inherently higher input impedance of the JFET-input transistors, without sacrificing the output drive associated with bipolar amplifiers. This makes them better suited for interfacing with high-impedance sensors or very low-power loads.

File format: PDF Size:1551 KB

UCD8220 and UCD8620 are members of the UCD8K family of analog pulse-width modulator devices to be used in digitally managed power supplies using a microcontroller or the TMS320™ DSP family. UCD8220 and UCD8620 are double-ended PWM controllers configured with push-pull drive logic. The UCD8620 has a 110-V high-voltage startup circuit which can directly start up the controller from a 48-V telecom input line. Systems using UCD8K devices close to 100% of the switching frequency range (i.e., 10 kHz to 2 MHz) and 1µA to 2A of output current, enabling high efficiency and performance.

File format: PDF Size:2388 KB

File format: PDF Size:0 KB

µA78L00C, µA78L00AC, µA78L05AI series are three-terminal regulators that can deliver up to 100 mA of output current. They do not require external components and have internal thermal overload protection and internal short-circuit current limiting features. These regulators can be used to eliminate noise and distribution problems associated with single-point regulation, and also with power-pass elements to make high-current voltage regulators.

File format: PDF Size:362 KB

File format: PDF Size:0 KB

The TPS7415/18/25/30/33 is a 200mA low dropout voltage regulator from Texas Instruments. It is available in 1.5V, 1.8V, 2.5V, 3V and 3.3V output voltages. It features fast transient response, can be stable with an output capacitance of 10µF, has a 3% output voltage tolerance, and is available in an 8-pin SOIC package.

File format: PDF Size:248 KB

tps3123 series products are a low voltage processor supervisory circuit, mainly used for dsp and processor systems.

File format: PDF Size:230 KB

The document describes the basic characteristics of the TPS310x, TPS311x family of supervisory circuits, including the precision supply voltage supervision range, high threshold accuracy, low supply current, RESET definition, power-on reset generator, etc.

File format: PDF Size:351 KB

The TPPM0301 is a low-dropout regulator with auxiliary power management that provides a constant 3.3-V supply at the output capable of driving a 400-mA load. The TPPM0301 provides a regulated power output for systems that have multiple input sources and require a constant voltage source with a low-dropout voltage. This is a single output, multiple input intelligent power source selection device with a low-dropout regulator for either 5VCC or 5VAUX inputs, and a low- resistance bypass switch for the 3.3VAUX input. Transitions may occur from one input supply to another without generating a glitch, outside of the specification range, on the 3.3-V output. The device has an incorporated reverse blocking scheme to prevent excess leakage from the input terminals in the event that the output voltage is greater than the input voltage. The input voltage is prioritized in the following order: 5VCC, 5VAUX, and 3.3VAUX.

File format: PDF Size:107 KB

SLAS418A is a low-power, high-performance audio codec with 16/20/24/32-bit 95-dB stereo playback, mono record functionality at up to 48 ksps. The product has several features, including high-quality stereo audio playback performance, microphone preamp, and hardware automatic gain control.

File format: PDF Size:763 KB

TLC5510, TLC5510A 8-bit high-speed analog-to-digital converters

File format: PDF Size:226 KB

TI reserves the right to make changes to their products or to discontinue any product or service without notice. Customers are advised to obtain the latest version of relevant information to verify the current and complete information before placing orders. TI warrants the performance of its semiconductor products according to the applicable specifications at the time of sale. TI's semiconductor products are not suitable for use in life-support devices or other critical applications. Adequate design and operating safeguards must be implemented by customers to minimize risks associated with the customer's applications.

File format: PDF Size:221 KB

THS8134, THS8134A, THS8134B are Texas Instruments' triple channel high precision 8-bit video D/A converters with a sampling rate of up to 80MSPS. The device can generate bi-level/tri-level sync and blanking levels in video applications.

File format: PDF Size:349 KB

SN54F04, SN74F04 HEX INVERTERS is a logic chip produced by Texas Instruments. It contains 6 independent inverters and has a working temperature range of -55 to 125℃.

File format: PDF Size:87 KB

The document describes the features and characteristics of the SLLS505F product, including the use of a 3.3V power supply, bus-pin ESD protection exceeding 16kV, optional driver output transition times, etc.

File format: PDF Size:264 KB

SCLS404E is a 4-bit synchronous binary counter designed for 2V to 5.5V voltage operation. It features internal look-ahead for fast counting, cascading output, and support for mixed-mode voltage operation.

File format: PDF Size:430 KB

The SN74CBT3384C is a high-speed TTL-compatible FET bus switch with low ON-state resistance (ron), allowing for minimal propagation delay

File format: PDF Size:335 KB