NXP UM10785 Fm+ Demo Board Software Installation Guide

This software installation guide shows you how to correctly load communications firmware on the Fm+ Demo Board OM13320 and the GUI software that runs under Win7 64-bit operating system. Please ignore any previous versions of software or firmware which may mention FM+DevelopmentBoard V03_00.bin, size 19kb,orFmDevelopmentBoardOM13260SoftwareInstall.zip, size 118MB. Also, there is no need to install the correct USB driver.

Brand: NXP
Category: demo board
Document type: Installation Guide
Language: English
Pages: 12
File format: PDF
File size: 370 KB
Published: 30 May, 2014
Updated: 25 September, 2023
MD5 checksum: 95D09D57A8DFABF042C701AF09255C7B
PDF: NXP UM10785 Fm+ Demo Board Software Installation Guide PDF

About this manual

This document serves as a software installation guide for the NXP Fm+ Demo Board, model OM13320. It details the procedures for loading the correct communications firmware onto the board's LPC 1343 microcontroller and installing the accompanying Graphical User Interface (GUI) software. The guide is specifically designed for use with a Windows 64-bit operating system.

What's inside

Introduction
Firmware Installation
GUI Installation
List of figures
Contents

Frequently asked questions

What operating system is required to run the GUI software?

The GUI software runs under the Windows 64-bit operating system.

Which USB port on the demo board should be used for the installation?

Connect the USB cable from the PC USB port to CN5.

What must be done to the ISP jumper to put the MCU into programming mode?

Install the ISP (JP6) jumper to put the MCU into In-System Programming mode.

Download PDF (370 KB)