Key facts
- Brand
- Garmin
- Model
- Reactor 40 Kicker
- Category
- Other Electronics
- Industry
- Electronics
- Documents
- 2
- Languages
- ZH · EN
- Last added
- 2026-11-08
Start here
Garmin REACTOR 40 KICKER Configuration Guide
This guide provides instructions for configuring the Garmin REACTOR 40 KICKER autopilot system. It details the use of the Dockside Wizard and Sea Trial Wizard to set up the system for specific boat dynamics and sensor calibration. Users are instructed on how to configure the system using either a helm control or a compatible chartplotter on an NMEA 2000 network.
Read onlineGarmin Reactor 40 Kicker specifications
| CCU data cable length | 5 m (16 ft) |
|---|---|
| ECU power supply | 12 to 24 Vdc |
| NMEA 2000 power supply | 9 to 16 Vdc |
| Minimum CCU distance from interference sources | 60 cm (2 ft) |
| Minimum distance from large magnets | 1.5 m (5 ft) |
Source: Garmin Reactor 40 Kicker Autopilot Installation Instructions
All Garmin Reactor 40 Kicker documents by type
Mounting, wiring and first power-up. Read it before the hardware goes in.
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
Who should install the autopilot system?
A qualified marine installer should install the autopilot system.
From: Garmin Reactor 40 Kicker Autopilot Installation Instructions
Where can the CCU be installed?
It can be installed in a non-buried location near the center of the boat, in any orientation.
From: Garmin Reactor 40 Kicker Autopilot Installation Instructions
What vessel type should be selected during the Dockside Wizard?
You must select the Power Displacement Hull vessel type.
What is the recommended maximum RPM value for the kicker motor?
The recommended maximum RPM value is 6000.