WIZnet WIZ820io user manual covering features, pin assignments, SPI read and write operations, dimensions, reference schematics, and warranty.
The WIZnet WIZ820io is an internet offload network module that combines the W5200 TCP/IP hardwired chip, including PHY, with a MAG-JACK RJ45 connector with transformer. The manual describes module features, pin assignments and descriptions, and the SPI procedures used by an external host to control the W5200.
The document also provides read and write processing sequences with pseudo code, mechanical dimensions, reference schematics, and the limited warranty terms for the module.
| Ethernet support | 10/100 Base TX |
|---|---|
| Duplex operation | Half/full duplex |
| Standards compliance | IEEE 802.3/802.3u |
| SPI interface | High speed SPI, Mode 0 and 3 |
| Supply voltage | 3.3V with 5V I/O signal tolerance |
| Hardware Internet protocols | TCP, IPv4, UDP, ICMP, ARP, PPPoE, IGMP |
| Hardware Ethernet protocols | DLC, MAC |
| Simultaneous connections | 8 independent connections |
| Power modes | Power down mode and Wake On LAN |
| Header interface | Two 2.54mm pitch 1 x 6 header pin |
| PCB size | 23mm x 25mm |
| Reset timing | At least 2us low, at least 150ms after high |
| Warranty period | One year |
The module includes the W5200 TCP/IP hardwired chip with PHY and a MAG-JACK RJ45 connector with transformer.
The W5200 operates as an SPI slave and supports SPI Mode 0 and Mode 3.
The data length is used: a length of 1 selects byte read processing, while a longer length selects burst read processing.
The PCB size is 23mm x 25mm.