Wiznet W5500 External Magnetic Component Reference Design

This document provides a reference design for the Wiznet W5500 chip, including circuit diagrams, component parameters, layout suggestions, and EMI…


Wiznet W5500 External Magnetic Component Reference Design - cover page
Brand
WIZnet
Category
Other Electronics
Document type
Application Note
Language
English
Pages
2
File format
PDF
File size
551 KB
Published
13 November, 2026
Updated
13 November, 2026
Model
W5500
MD5 checksum
22789BC6A1758075739CA8E73F67344B

About this manual

This document serves as a reference design for the Wiznet W5500 network interface chip. It details the external magnetic component layout and provides specific recommendations for hardware design optimization.

Key design guidelines include the application of damping resistors (specifically 33 ohms) for EMI reduction, avoiding the placement of power jacks near the RJ-45 connector, and voiding power and ground planes under discrete magnetic components. The document also specifies the use of stable power sources, high-quality CAT5E cables, and ferromagnetic beads between digital and analog voltage domains.

What's inside

  • Damping resistor
  • EMI reduction
  • Power layout
  • Signal traces
  • Power quality
  • CAT5E cable
  • Ferromagnetic bead
  • Circuit diagram
  • Component parameters
  • Wiring suggestions

Specifications

Damping resistor value33 ohms
Ferromagnetic bead impedance100 to 2000 ohms at 100MHz
Filter capacitor value25MHz

Frequently asked questions

What damping resistor value is recommended for EMI reduction?

A 33 ohm resistor was found to be the best value for EMI reduction in this design.

What impedance is adequate for a ferromagnetic bead between digital and analog power?

An impedance between 100 and 2000 ohms at 100MHz is considered adequate.

Download PDF (551 KB)

More WIZnet Manuals


View all WIZnet manuals →