Texas Instruments S2000 Reader Configuration Manual

This manual explains how to install USB drivers and configure the Texas Instruments S2000 RFID reader using Windows HyperTerminal.

Brand: Texas Instruments
Category: Other device
Document type: User Manual
Language: English
Pages: 32
File format: PDF
File size: 946 KB
Published: 29 September, 2026
Updated: 29 September, 2026
Model: S2000
MD5 checksum: 259D2F51C83656158948B106213DC963
PDF: Texas Instruments S2000 Reader Configuration Manual PDF

About this manual

The document provides step‑by‑step instructions for establishing a USB connection to the S2000 Reader and modifying its EEPROM settings. It is intended for engineers familiar with RFID devices and covers driver installation, HyperTerminal setup, and parameter configuration.

Key procedures include creating the installer folder, installing the TI USB drivers, connecting the reader with jumper J11 in place, and using Windows HyperTerminal to read or write EEPROM values. Default EEPROM values are listed in Appendix A, and the required dipswitch setting for configuration is described.

What's inside

Preface
Configuration Overview
USB Interface
Windows HyperTerminal
Configuration Steps
EEPROM Addresses
Appendix A – Default EEPROM Values
Appendix B – Installing USB Drivers

Specifications

USB interface enable	Jumper J11 must be in place
Default EEPROM values	See Appendix A

Frequently asked questions

How do I install the USB drivers for the S2000 Reader?

Extract the installer folder and run the setup.exe file; the drivers will be installed automatically.

Download PDF (946 KB)