Installation guide for Sylvania Automotive LED light assemblies covering mounting, wiring, relay and switch placement, testing, and safety warnings.
This Sylvania Automotive installation guide explains how to mount LED light assemblies on a vehicle and connect them through the supplied wiring harness. It covers attaching the red and black wires, connecting the harness to battery power or a switched +12V power source, and testing the LEDs with the harness switch.
The guide also describes mounting the relay with its connector facing down, securing the switch, and routing wiring away from pinch points, sharp surfaces, and moving parts. A warnings section covers safe mounting, heat, off-road use, and checking local motor vehicle requirements.
| Power source | Switched +12V power source |
|---|---|
| Lens orientation | Vertical when the vehicle is on a level surface |
Mount it where it does not interfere with or block existing vehicle systems.
For each grouping, attach the black wire from the harness to the black wire on the LED assembly, and the red wire to the red wire.
Secure it closest to the vehicle battery with the relay connector facing down to keep water out.
No. The instructions say not to operate the LED assembly while driving on public roads.