This SolarEdge application note explains how to generate advanced power charts for reactive power and power factor on SE12.5K–SE100K three-phase inverters.
This application note describes the Advanced Power Charts feature in the SolarEdge monitoring platform, which provides visibility into reactive power and power factor measurements for three-phase inverters.
The charts are available at the inverter level for SE12.5K–SE100K inverters with firmware version 3.18xx and above, and support both display-equipped and SetApp-configured inverters.
| Supported inverter models | SE12.5K – SE100K three-phase inverters |
|---|---|
| Required firmware version | 3.18xx and above |
| Chart availability | Inverter level only |
| Data availability start date | August 2019 |
The charts are calculated only for dates starting August 2019, so other historical data is not available and past dates appear as 0.
Due to harmonic distortions, the reactive power may be larger than 0 even when the CosPhi was set to 1.
No. Currently, the advanced power charts can only be generated for inverters and not for the entire site.
This can happen when the inverter’s power output is low and certain distortions might be spotted with the configured CosPhi.