Parts catalogue and technical guide for the Seiko Cal. 6T63A quartz chronograph movement, covering specifications, parts, checks and troubleshooting.
This document is the parts catalogue and technical guide for the Seiko Cal. 6T63A movement, a multi-display analogue watch with a stopwatch function. The specifications page gives the hand movement interval of 1 second, a stepping motor with two pieces and 0 jewels, a SEIKO SR936SW battery of 1.55 V with a battery life of approximately 3 years, a monthly rate of less than 20 seconds, current consumption of less than 2.70 μA for the movement and less than 0.70 μA for the circuit block, coil resistances for coil blocks A and B, and a movement measuring Ø 30.8 mm outside and 5.1 mm in height. The watch has hour, minute and small second hands, a 24-hour indicator and a date indicator, and the stopwatch measures up to 60 minutes in one second increments and stops automatically after 60 minutes.
The technical guide describes the chronograph construction based on the Cal. 8R28 mechanical chronograph watch with a one-piece 3 pointed reset hammer, and the self-alignment function that returns all counting hands to zero. It also covers the necessary procedure after battery change, a detailed parts list with part numbers, the tools and watch oils required, how to find the correct parts using the numeral 2 or 4 printed on the dial, operation and function checks, water resistance test methods and pressures, and a troubleshooting table of symptoms, causes and solutions.
| Driving system | Stepping motor, 2 pieces |
|---|---|
| Battery | SEIKO SR936SW, 1.55 V |
| Battery life | Approx. 3 years |
| Number of jewels | 0 |
| Monthly rate | Less than 20 seconds |
| Gate time for rate measurement | 10-second gate |
| Current consumption (movement) | Less than 2.70 μA |
| Current consumption (circuit block) | Less than 0.70 μA |
| Coil resistance (Coil block A) | 1.45 - 1.65 KΩ |
| Coil resistance (Coil block B) | 1.65 - 1.85 KΩ |
| Diameter outside | Ø 30.8 mm |
| Casing diameter | Ø 29.0 mm |
| Stopwatch measuring range | Up to 60 minutes in one second increments |
It uses a SEIKO SR936SW battery with a voltage of 1.55 V and a battery life of approximately 3 years.
It measures up to 60 minutes in one second increments, and after 60 minutes it stops automatically.
The monthly rate is less than 20 seconds when the watch is worn on the wrist at a temperature between 5 and 35.
SEIKO watch oil AO-3 (or Moebius A) and AO-2 (or Moebius F).