Seiko instruction manual for the Cal. 5Y66/5Y67 analog quartz watch, covering day and time setting, date setting, battery change and specifications.
This is the Seiko instruction booklet for the Cal. 5Y66/5Y67 analog quartz watch. It explains the parts of the watch and the crown positions, then walks through day and time setting, date setting and battery change, and ends with a specifications page. The booklet also notes that the retrograde day indicator returns to the first day of the week when the crown is turned clockwise past the last day, and that the date should not be set between 9:00 p.m. and 1:00 a.m.
The same booklet is printed in several languages, with the English instructions first and versions in German, French, Italian, Spanish and Portuguese following. For care of the watch, it refers the reader to the attached Worldwide Guarantee and Instruction Booklet.
| Frequency of crystal oscillator | 32,768 Hz |
|---|---|
| Loss/gain (monthly rate) | Less than 20 seconds on the wrist within 5 °C ~ 35 °C |
| Operational temperature range | –5 °C ~ +50 °C (23 °F ~ 122 °F) |
| Driving system | Step motor |
| Battery | SEIKO SR920SW, 1 piece |
| Battery life | Approximately 3 years |
| IC (Integrated Circuit) | C-MOS-IC, 1 piece |
| Display system | 24-hour, hour, minute and second hands; day and date indicated by hands |
Pull the crown out to the second click when the second hand is at the 12 o'clock position, turn the crown to set the day hand and the time, then push the crown back in according to a time signal.
Do not set the date hand between 9:00 p.m. and 1:00 a.m., as it may not turn properly.
It uses one SEIKO SR920SW battery, which should last approximately 3 years.
The stated operational temperature range is –5 °C to +50 °C (23 °F to 122 °F).