Hardware installation guide for Ruijie RG-EG V2 series routers, covering preparation, cabling, power connection, startup, and troubleshooting.
This manual provides hardware installation instructions for the Ruijie RG-EG V2 series of system routers. It is designed for network engineers, technical promotion personnel, and network administrators who have experience in installing and maintaining network hardware.
The guide covers product introduction, safety precautions, environmental requirements, physical installation steps including cabling and power connection, initial startup procedures, configuration environment setup, and common fault troubleshooting. This manual is written in Chinese.
| CPU | Dual-core processor, 880MHz |
|---|---|
| Flash Memory | 16MB |
| SDRAM | 128MB (RG-EG105G V2) / 256MB (RG-EG205G V2) |
| Power Input | AC 100-240V, 50/60Hz |
| Operating Temperature | 0º C ~ 40º C |
| Storage Temperature | -40º C ~ 70º C |
The default management address is http://192.168.110.1.
Press and hold the Reset button for more than 5 seconds until the system indicator flashes, then release.
The connection requires 100-ohm Category 5 or higher unshielded twisted pair (UTP) or shielded twisted pair (STP) cables.