Specifications and operating guide for the Peavey P1BT/P2BT column powered speakers, covering features, panel controls, Bluetooth pairing and FCC/IC compliance.
This document provides the specifications for the Peavey P1BT/P2BT Column Powered Speaker Systems. The P Series BT is described as a compact, lightweight, low-profile portable speaker system with a 3-channel onboard mixer, two XLR mic inputs with 1/4" line inputs, RCA/3.5mm stereo media inputs, and Bluetooth audio input for streaming. The P1BT and P2BT have 180 and 200 watts maximum power respectively, and units can link with other P Series speakers for stereo operation.
The document also covers installation clearances, the top and input panel controls (level, EQ, master volume, sync XLR in/out, subwoofer out), Bluetooth pairing and stereo linking steps, plus the FCC/ICES compliancy and radiation exposure statements. Peavey notes the systems are intended for church, convention, DJ or club applications.
| P1BT maximum power | 180 Watts |
|---|---|
| P2BT maximum power | 200 Watts |
| P1BT drivers | 2x6.5" woofers with 1" (25mm) high-frequency compression driver |
| P2BT drivers | 3x6.5" woofers with 1" (25mm) high-frequency compression driver |
| Mixer channels | 3 Channel mixer |
| Mic/line inputs | 2 XLR mic inputs and 1/4" line inputs |
| Media input channel | RCA/3.5mm stereo input channel |
| Power supply | AC 100-240Vac, 50-60Hz |
| Fuse | F2.5AL/250V |
| EQ tone controls | Shelving type, +/-15dB (low and high) |
| Installation clearances | Top 8", sides 12", back 12" from combustible surfaces |
| Radiation exposure distance | Minimum 20 cm between radiator and body |
Press the mode button on the back of the speaker to make it discoverable, then select the available Peavey speaker on your device's Bluetooth screen. Once paired, the pairing LED lights continuously.
Pair your Bluetooth device to the first speaker, press Pairing on the second speaker to turn Bluetooth on, then press the Stereo Link button on both speakers. Press Stereo Link again on either speaker to disconnect.
Yes, the 1/4" Subwoofer Out jack can drive an external subwoofer amplifier or a power sub, with a signal level that is pre-master volume control.
The unit must have 8" clearance on top and 12" on the sides and back from any combustible surface.