ON Semiconductor NCV7750GEVB Evaluation Board User's Manual

User's manual for the ON Semiconductor NCV7750GEVB evaluation board, covering the NCV7750 quad low-side relay driver, SPI control and fault modes.


ON Semiconductor NCV7750GEVB Evaluation Board User's Manual - cover page
Brand
ON Semiconductor
Category
Other Electronics
Document type
User Manual
Language
English
Pages
15
File format
PDF
File size
1.3 MB
Published
10 November, 2026
Updated
10 November, 2026
MD5 checksum
138A154C82F8CEF8BC15ACAA9E05C4C2

About this manual

The NCV7750GEVB evaluation board demonstrates the NCV7750, a quad low-side relay driver for automotive applications such as a Body Control Unit (BCU) or Engine Control Unit (ECU). Each of the four independently controlled channels has overcurrent, overtemperature and open-load detection that is reported back through SPI. On the board, each channel uses an NEC EX2 automotive relay as a load switching an LED, with a button for generating an overcurrent condition and a jumper for an open-load condition; outputs are set with DIP switches and shown on an LCD.

The manual describes board setup with a ~14 V supply at the VBAT banana input, the LCD user interface and its status modes (Disabled, Ready, Continuous, Demo, Limp Home), SPI transmission using the SI, SO, SCLK and CSB pins, single and continuous command transmission, demo mode, Limp Home mode, and the jumpers and test posts used for external input and monitoring.

What's inside

  • Description
  • Features
  • Application
  • Communication
  • User Interface Locations
  • Using the NCV7750GEVB
  • Demo Mode
  • Transmitting SPI Commands
  • Limp Home Mode
  • Using external input

Specifications

Driver channelsFour independently controlled low-side channels
Output driver current600 mA per driver
Inductive load clamp voltage36 V minimum
Communication interfaceSPI (SI, SO, SCLK, CSB)
On-board relay loadNEC EX2 automotive relay per channel
Board supply input~14 V to VBAT banana input

Frequently asked questions

How does the NCV7750 communicate?

Communication is accomplished through a SPI bus using the SI, SO, SCLK and CSB pins.

What supply voltage is connected to the NCV7750GEVB?

The user connects a supply of about 14 V to the VBAT banana input and ground to the GND banana input.

How do you enter Limp Home mode?

Put the LHI DIP switch into the upwards position; the NCV7750 then enters Limp Home mode regardless of its previous mode.

How much current can each output driver sink?

Each power transistor output driver may sink 600 mA of current.

Download PDF (1.3 MB)

More ON Semiconductor Manuals


View all ON Semiconductor manuals →