Norbar PneuTorque Standard Series Stall Tools Remote Control Air Motor Operator's Manual

Operator's manual for Norbar PneuTorque Standard Series remote control air motors (PT 1–PT 18), covering safety, setup, operation and maintenance.


Norbar PneuTorque Standard Series Stall Tools Remote Control Air Motor Operator's Manual - cover page
Brand
norbar
Category
Industrial Supply
Document type
User Manual
Language
English
Pages
23
File format
PDF
File size
939 KB
Published
10 November, 2026
Updated
10 November, 2026
MD5 checksum
1B40F5AA93868140AA070BFFE5B66DC8

About this manual

This operator's manual (part number 34318, issue 5, original English instructions) covers the Norbar PneuTorque Standard Series stall tools with remote control air motor. It applies to all PneuTorque (PT) Remote Standard Series models from PT 1 to PT 18, available in single speed manual, two speed manual and two speed automatic versions, with drive squares from ¾" to 3½" and maximum torques from 680 N·m to 300,000 N·m.

The contents include safety instructions covering projectile, entanglement, noise, vibration, dust and pneumatic-specific hazards, followed by an introduction, features and functions, setup instructions including torque reaction, torque setting for fastener tightening and loosening, operating instructions, maintenance of the reaction plate, gearbox, silencer and filter, specifications, a Declaration of Incorporation, trouble shooting and a glossary of terms.

What's inside

  • Safety
  • Introduction
  • Features and Functions
  • Set up Instructions
  • Operating Instructions
  • Maintenance
  • Specifications
  • Declaration of Incorporation
  • Trouble Shooting
  • Glossary of Terms

Specifications

Models coveredPneuTorque PT 1 to PT 18 Remote Standard Series
Control versionsSingle Speed Manual, Two Speed Manual, Two Speed Automatic
Drive squares¾" to 3½" depending on model
Maximum torque (smallest model, PT 1)680 N·m
Maximum torque (largest model, PT 18)300,000 N·m

Frequently asked questions

Which PneuTorque models does this manual cover?

It covers all PneuTorque (PT) Remote Standard Series tools, from PT 1 up to PT 18, in single speed manual, two speed manual and two speed automatic versions.

What should I do before changing accessories on the tool?

Shut off the air supply, drain the hose of air pressure and disconnect the tool from the air supply before changing accessories or making repairs.

Is there a separate manual for PneuTorque tools supplied with a handle?

Yes, handle versions carry a part number without an 'X' suffix and are covered by operator's manual part number 34317.

What eye protection is required when operating the tool?

Always wear impact-resistant eye protection during operation; the grade of protection required should be assessed for each use.

Download PDF (939 KB)

More norbar Manuals


View all norbar manuals →