This manual introduces the operation methods of NORBAR JOINT SIMULATION RUNDOWN FIXTURES, including the operation instructions of 50313, 50251, 50252, 50253, 50254 and other models.
The Norbar Joint Simulator, part number 34290, is designed to measure the torque output of power torque tools by simulating the working conditions of screwed or bolted joints. It achieves this by using spring washers arranged in various serial or parallel combinations to represent joints of varying stiffness, such as 'soft' or 'hard' pull-up conditions. The fixture is used in conjunction with Norbar Torque Transducers and instruments.
| Torque Range (50313) | 0.2 – 2 N∙m (2 – 25 lbf∙in) |
|---|---|
| Torque Range (50251) | 2 - 10 N∙m (20 – 100 lbf∙in) |
| Torque Range (50252) | 5 – 50 N∙m (5 – 50 lbf∙ft) |
| Torque Range (50253 & 50693) | 10 - 140 N∙m (10 – 100 lbf∙ft) |
| Torque Range (50254 & 50694) | 100 - 700 N∙m (100 – 500 lbf∙ft) |
| Bolt Size (50313) | M6 x 1.0 |
| Bolt Size (50252) | M10 x 1.0 |
| Bolt Size (50253, 50693) | M12 x 1.25 |
| Bolt Size (50254, 50694) | M24 x 3.0 |
It is designed to measure the torque output of power torque tools by simulating the working conditions of screwed or bolted joints.
Spring washers are arranged in various serial or parallel combinations to represent joints of varying stiffness, such as 'soft' or 'hard' pull-up conditions.
Exceeding the maximum torque for washer make-up will result in permanent damage to the washers.
The bolt and washers should be kept greased with a graphite loaded grease, such as Rocol M204 G or Rocol Tufgear 85.