The ICP DAS I-7540D manual explains hardware, software tools, configuration and troubleshooting for the Ethernet‑to‑CAN converter.
This manual provides a complete overview of the I-7540D Ethernet to CAN converter, including its key features, hardware block diagram, connector pin definitions, and wiring for RS‑232, RS‑485, CAN and Ethernet interfaces. It also describes the built‑in self‑diagnostic functions and the LED indicators that help monitor power, CAN bus status, and the seven‑segment displays.
The document details the accompanying software utilities (I‑7540D Utility, MINIOS7 Utility, VXCOMM Utility), how to install drivers, set communication parameters such as IP address, baud rates, CAN acceptance code/mask, and how to use the provided command list. Troubleshooting steps, error codes, and procedures for establishing virtual COM ports are also included. This manual is written in Chinese.
| CPU | 80186, 80 MHz (or compatible) |
|---|---|
| Flash Memory | 512 KB |
| SRAM | 512 KB |
| Ethernet Port | 10/100 Base‑TX with auto‑negotiation |
| CAN Isolation Voltage | 2500 V rms |
| Operating Temperature | -25 °C to +75 °C |
| Power Supply | +10 V to +30 V DC |
| Power Consumption | 2.5 W |
Use the I‑7540D Utility to configure the network IP address, gateway and subnet mask.
The default IP address is 192.168.255.2.
Verify the power supply, network cable, IP address, subnet mask and gateway, and ensure the VxComm driver is running.