Installation and configuration guide for Hunter A2C-LTE and A2C-CELL-E cellular communication modules used with Hunter ACC2 controllers.
This guide covers preparation, physical installation, SIM card replacement, antenna installation, configuration, software setup, firmware verification, compliance information, and troubleshooting for the Hunter A2C-LTE and A2C-CELL-E cellular communication modules.
The modules are used with Hunter ACC2 controllers and include steps for connecting the controller to a Hunter Centralus account, including APN selection, billing setup, and controller verification.
| North America module | A2C-LTE |
|---|---|
| Other regions module | A2C-CELL-E |
| Antenna cable length | approximately 9' (2.8 m) |
| Plastic controller antenna hole | ½" (13 mm) |
| Maximum signal strength | -51 dBm |
| Adequate signal strength | -85 dBm |
| Unreliable signal strength | -99 dBm or higher |
| North America APN | zipitwireless.com.attz |
| International APN | aws.inetd.gdsp |
| Metal enclosure wall bracket model | 10010100 |
| Plastic pedestal lid adapter model | 10010000 |
The A2C-LTE cellular communication module is designed for use in North America.
zipitwireless.com.attz is pre-selected for most users in North America.
A signal of -85 dBm is generally adequate for reliable communications.
Yes, a free Hunter account is required to add a controller.