HB100 X-band bi-static Doppler transceiver module: specifications, antenna patterns, installation notes and example application circuits.
The HB100 is an X-band bi-static Doppler transceiver module with a built-in dielectric resonator oscillator (DRO) and a pair of microstrip patch antennas. The document presents it for OEM motion-detection equipment, including microwave/PIR intrusion detectors, automatic door opening, lighting control and vehicle speed measurement. The English pages cover features, block diagram and connection, antenna beam patterns, an outline diagram and a specification table measured at +5 VDC, CW operation, 12 kΩ load and +25 °C.
The Chinese pages add installation notes (soldering the +5V, GND and IF pads, removing the wire that protects against static damage, antenna orientation and the three types of IF output signal), the Doppler equation Fd = 2v(Ft/c)cos q, and three example circuits: an automatic door / ATM recording control with 4–15 m adjustable range, a train signal switch circuit with 1–9 m range, and a PIR/microwave combined detector built around a PIC16C622A microcontroller. This manual is written in Chinese.
| Frequency Setting | 10.520 GHz min, 10.525 GHz typ., 10.530 GHz max |
|---|---|
| Radiated Power (EIRP) | 12 dBm min, 15 dBm typ., 20 dBm max |
| Supply Voltage | 4.75 VDC min, 5.00 VDC typ., 5.25 VDC max |
| Current Consumption | 30 mA typ., 40 mA max |
| Antenna Beam-width (3 dB) - Azimuth | 80° |
| Antenna Beam-width (3 dB) - Elevation | 40° |
| Settling Time | 6 µSec |
| Pulse Repetition Frequency | 2 kHz |
| Operating Temperature | -15 °C to 55 °C |
| Weight | 8 g |
| Detection range | 15–20 m; a wider range may also be possible |
The Chinese text gives a detection range of 15–20 m and notes that a wider range may also be possible; a later page states the range exceeds 20 m.
Solder the +5V, GND and IF (signal) pads as marked on the module, and remove the bare wire on the module that protects it from static damage during transport before use.
The supply voltage range is 4.75 to 5.25 VDC with 5.00 VDC typical, and current consumption is 30 mA typical, 40 mA maximum.
The document gives Fd = 2v(Ft/c)cos q, where Fd is the Doppler frequency, v the target speed, Ft the transmit frequency, c the speed of light and q the angle; at 10.525 GHz this becomes Fd = 19.49V (km/h).