HB808C is a new type of low-voltage hybrid servo product that uses the latest DSP digital processing chip and advanced variable current and variable frequency control algorithm technology to provide equipment manufacturers with a cost-effective hybrid servo drive solution.
HB808C is a low-voltage digital hybrid servo drive developed from the company's low-voltage servo experience. It uses a DSP digital processing chip and advanced variable current and variable frequency control algorithms, and is described as compact with low heat, vibration and noise.
The manual covers product introduction, electrical, mechanical and environmental specifications, drive interfaces and wiring, control signal timing and modes, DIP switch settings, protection functions, common problems and warranty terms. This manual is written in Chinese.
| Continuous output current (maximum) | 8.0 A |
|---|---|
| Peak current (maximum) | 13 A |
| DC input voltage | 24-80 Vdc (recommended 36/48 V) |
| Logic input current | 6-16 mA |
| Logic input voltage | 4.5-28 Vdc |
| Maximum pulse frequency | 500 kHz (default 200 kHz) |
| Pulse high-level width | 1.5 us minimum |
| Position error control accuracy | ±1 pulse |
| Speed control accuracy | ±2 rpm |
| Maximum acceleration (no load) | 100 rpm/ms |
| Overvoltage protection | 90-94 Vdc |
| Insulation resistance | 100 MΩ |
| Cooling method | Natural or forced air |
| Humidity | 40-90% RH |
| Vibration | 10-55 Hz / 0.15 mm |
| Storage temperature | -20 to +65 °C |
| Operating altitude | ≤1000 m |
| Weight | about 1.4 kg |
| Encoder lines | 250-5000 lines |
| Compatible motor frames | 28, 35, 42, 57, 60 and 86 |
| Recommended motor torque | 0.3, 0.4, 0.6, 0.8, 1.0, 2.4, 3.0, 3.6, 4.5 and 8.5 Nm |
| Control modes | Position, speed and torque |
| Input signal type | Differential and single-ended pulse/direction |
| Control technology | FOC and SVPWM closed-loop control |
| Pulses per revolution | Settable via software or DIP switch |
| Protection functions | Overvoltage, undervoltage, overcurrent and tracking error |
| Pulse/direction modes | Single/dual pulse and pulse edge selectable |
| Control input level | 4.5-28 V compatible |
| Debug interface | RS232, requires dedicated cable |
| Fault indication | Red LED flashes at 2 Hz |
| Fault history storage | Up to 10 latest faults in EEPROM |
| Alarm output | Open-collector, max pull-up 24 V, max 100 mA |
| Control port | 8-pin 3.81 mm terminal |
| Power port | 3-pin 3.81 mm terminal |
| Encoder port | 6-pin 3.81 mm terminal |
It is suitable for various small and medium automation equipment and instruments, such as screw locking, wire stripping, winding, terminal, laser, engraving, electronic processing, automatic gripping, CNC, packaging and robot equipment.
The DC input voltage is 24-80 Vdc, with a recommended operating voltage of 36/48 V.
The red LED flashes in a 5-second cycle, and the number of flashes within 5 seconds indicates the fault.
Yes, but the company must be contacted to provide motor parameters and match the corresponding program.